Electric Iron Repair

Iron Power Indicator Light Not On
         Indicator lights flash no electric irons there are 2 indications, that the power cord is broken or loose board and indicator lights off or broken, to fix this problem, follow these steps:
disconnect the power cord or the connecting cable from the wall socket. make sure the cable does not break and can still be used. remove the rear cover and note the connecting cables and indicator lights. if the connecting cable or off the indicator lights, lamps and cable back.If plug securely in place, check out the following sections:
- Check the resistor or resistance inherent in the indicator light if any.
- Check the value of the resistor with multitester, resistors are usually weak or damaged hair can lead indicator lights off.
- If the resistor is normal, check the indicator light. indicator lights are usually marked with a black die or drop out bulb in the lamp.
Check the lamp if it looks black and filament broke, replace with a new indicator lights.

Electric iron thermostat does not work
            Heat registers are not usually due to the use of the road does not comply with its user instructions or because the board has been dropped or hit by hard objects other (so that the composition of existing mechanical thermostat that turns). to correct this problem, follow these steps:
unplug the power cord from the wall socket, rear cover, tongkai holders, and tongkai cover, remove the casing cover.
platinum automatic check to determine the condition of rotating On-Off still in good condition or not, clean the platinum contact with emery paper or paper pads. then try adjusting the settings of platinum by using a small flat-head screwdriver.
if you have a thermostat that flatiron connect with platinum element automatically, check tidakdgn still connected or using a multitester. if dropped immediately replace with a new one.
Iron flame, but do not produce heat
unplug the power cord from the wall socket, remove all the casing, check to determine the condition of platinum automatic turn On-Off still in good condition or not, immediately replaced if damaged.
check the thermostat by using a multitester, still connected with perfect or not, make sure the thermostat is working.
Last thing is the heating element, check with multitester, if damaged replace immediately.

Body-voltage electric irons
            Often board that old age, if held badanya, feels voltage listrik.selain age, board consumables or the use of which fell for too long can cause problems ini.untuk mitigate agency problem-voltage board
disconnect the cable from the wall socket, remove covers to the board.
check the connecting cable, if the cable is damaged or there is a loose fibers, immediately replace it with a new-wires.
off all the outer casing, check thermostatnya. damaged the mechanical thermostat which can lead to leakage currents.
check the heating elements, insulation damage patched with plaster or replace with a new one, check one by one the other components pertinent electricity by using a multitester or tespen.
Iron Dead
check the power cable, if the cable is within good condition, the next step is to disassemble the body board and check the heating element using a multitester. attach the first end of the heating element on multitester wires red, black affixed to the ends of the heating element which lain.apabila multitester needle does not move, it means the heating element is off or not functioning.
disconnect the heating element, replace with a new element by adjusting the specifications that the previous element.

Caring for Electric Iron
do the routine maintenance of electric irons, especially the ironing, when finished used for ironing clothes, wipe with a cloth that has been moistened with petrol / thinner. if it is too hard and thick, wipe with a thin plate, or on a base plate is still hot, spread with wax and then rub with a clean cloth reply.
avoid ironing on the buttons and zippers, in order to keep a good base plate.
Another part that should be maintained is the connecting cables, terminals, and plugs.
noticed when wearing board, position the power cord in a state not to rotate or twist, if it happens immediately straightened.
for normal use platinum automatic suits the player should not be played until a maximum, just use half alone.
to put the board should put a little to the middle so as not to fall over, or use a place to put the irons.